|
[Sponsors] |
February 11, 2003, 06:41 |
Unigraphics -> CFX4 Build
|
#1 |
Guest
Posts: n/a
|
I'm trying to import a geometry from Unigraphics (version 18) into CFX Build. First I export a parasolid from UG (test10.xmt_txt), thereby putting the version to 17 (I have read that only files from UG versions 17 and lower can be imported). Then I try to import this file into CFX-build, but get the following error:
'Unigraphics reports error opening file ./test10-ps0001.xmt_txt. Check partfile, path name, version number and run time enviroment variables and/or support files.' So it look likes UG gives the error. Can it be a problem that UG and CFX4 are not running on the same computer. So I'm modelling in UG on a other computer than where CFX4 is running on. When I export a file from UG I copied it to the other computer. Can anybody help me out, with thanks in advance, Vincent. |
|
February 11, 2003, 16:04 |
Re: Unigraphics -> CFX4 Build
|
#2 |
Guest
Posts: n/a
|
Hi Vincent,
Try exporting the parasolid from UG as a version 11 parasolid (I think that's right). The cryptic error message from Build is trying to say it can't understand the file as it is a different version. Glenn |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
64bitrhel5 OF installation instructions | mirko | OpenFOAM Installation | 2 | August 12, 2008 18:07 |
BUILD MESH: CFX4 | RK | CFX | 0 | June 25, 2005 06:12 |
CFX4 Build | KKA | CFX | 7 | December 10, 2003 01:01 |
need ICEM CFD HEXA ---> CFX4 example | leonard | CFX | 3 | October 18, 2002 07:53 |
Unigraphics --> Fluent | Megan | FLUENT | 2 | October 25, 2000 10:47 |