Interpolate inlet-profile -- CFD Online Discussion Forums

February 20, 2003, 09:18	Interpolate inlet-profile	#1
cujo Guest Posts: n/a	Hi, I have an axisymmetric case in CFX 5 (periodic boundaries, symmetry wall at center and 3 element layers thick) in which I impose a velocity profile at an inlet slit between two Walls. When I plot the inlet velocity at the inlet plane, the inlet profile that I imposed looks 'smeared out'. The velocity (u,w) isn't even zero at the walls besides the inlet slit! When comparing the CFX5 results with results from CFX4 (same mesh), the velocity profiles differ slightly, which, to my opinion, is due to the different inlet profiles. Is this problem known to you? Is there a workaround? Regards, Cujo

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Boundary Profile	E61	FLUENT	0	January 5, 2011 08:13
patching velocity profile to the inlet face of domain	vasuaero1988	Fluent UDF and Scheme Programming	1	September 29, 2010 03:49
translational periodic BC vs Fully Developed Profile at Inlet	Prakash.Paudel	FLUENT	1	August 20, 2010 11:01
create logarithmic wind profile for inlet	Murat	Main CFD Forum	0	December 30, 2003 00:45
inlet velocity profile in Polyflow	srinu	FLUENT	0	January 16, 2003 20:25

All times are GMT -4. The time now is 11:58.