Generating Mesh (CFX)

February 25, 2003, 11:34

Just a Basic question. I am building a mesh to simulate the space in a room

I am interested in knowing how to generate a fine mesh at the bottom of the room and a coarser mesh at the top.

February 25, 2003, 11:53

Hi Steven,

You can put a mesh control on the bottom surface (floor) and in the global settings, specify a low expansion ratio (1.05 for instance).

Alternatively, you could put two triangular mesh controls at the bottom and specify the radius of influence and mesh expansion ratio to give you the desired effect.

Regards, Robin

February 25, 2003, 11:34	Generating Mesh (CFX)	#1
Steven Guest Posts: n/a	Just a Basic question. I am building a mesh to simulate the space in a room I am interested in knowing how to generate a fine mesh at the bottom of the room and a coarser mesh at the top.

February 25, 2003, 11:53	Re: Generating Mesh (CFX)	#2
Robin Guest Posts: n/a	Hi Steven, You can put a mesh control on the bottom surface (floor) and in the global settings, specify a low expansion ratio (1.05 for instance). Alternatively, you could put two triangular mesh controls at the bottom and specify the radius of influence and mesh expansion ratio to give you the desired effect. Regards, Robin

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Create moving mesh without simulating (CFX)	spatialtime	ANSYS	2	July 22, 2010 10:30
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55
hex mesh using cfx mesh.	mehul	CFX	0	October 31, 2005 07:01
Mesh from ICEM CFD to CFX ! Error ! Why ? Thanks !	Vu Trinh Tuan	CFX	11	March 28, 2005 19:04
importing mesh from ICEM CFD into CFX 5	Jay	CFX	2	November 12, 2002 13:46