 |
 |
 |
|
|
|
[Sponsors] | ||||
March 25, 2003, 04:26
|
ellipse in Build 5.5
|
#1 |
|
Guest
Posts: n/a
|
Hi!
Can somebody, please tell me how to make an ellipse in CFX Build 5.5. It should be really easy, but I canīt find out how and it makes me crazy... Thanks! /Eve |
|
|
||
|
March 25, 2003, 16:24
|
Re: ellipse in Build 5.5
|
#2 |
|
Guest
Posts: n/a
|
Hi Eve,
Here's one way: Draw a circle (eg Create/Curve/2D circle), then scale it (transform/curve/scale). The three numbers in the scale factor (default 1.0 1.0 1.0) are the scaling multiple in the x, y and z directions respectively. Regards, Glenn Horrocks |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] problem with the ellipse curvededge | alvin11 | OpenFOAM Meshing & Mesh Conversion | 5 | December 1, 2017 06:41 |
| 2D rotating ellipse (domain interface??) | Kambusha | CFX | 38 | May 19, 2012 07:10 |
| 64bitrhel5 OF installation instructions | mirko | OpenFOAM Installation | 2 | August 12, 2008 18:07 |
| Build 5.5 error message | Bogesz | CFX | 0 | May 6, 2002 13:44 |
| Edit surface in Build 5.5 | Bogesz | CFX | 1 | May 2, 2002 09:15 |
Linear Mode
