|
[Sponsors] |
June 4, 2003, 22:57 |
How to add body force in CFX5.5
|
#1 |
Guest
Posts: n/a
|
Hi all! If I want to add body force, such as gravity and Lorentz forcce, to the fluid, how can I put it into practice in CFX5.5? By using CEL or subroutine?
Best regards! Miko |
|
June 6, 2003, 17:04 |
Re: How to add body force in CFX5.5
|
#2 |
Guest
Posts: n/a
|
Gravity can be added by specifying buoyancy in the Domains form. General body forces can be added with momentum source terms (and perhaps CEL).
Robin |
|
June 7, 2003, 10:29 |
Re: How to add body force in CFX5.5
|
#3 |
Guest
Posts: n/a
|
Thank you Robin! Yes, I should creat a sub-domain! Thank you again!
Best regards! Miko |
|
June 17, 2003, 23:11 |
Re: How to add body force in CFX5.5
|
#4 |
Guest
Posts: n/a
|
Hi Robin!
I want to know how to add gravity by specifying buoyancy? Another question is how to use sub-domain to add general body force with momentum source terms. Can you give me guildlines? Thank you! Best regards! Miko |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to add a source term (body force) to icoFoam? | chris Liu | OpenFOAM Programming & Development | 4 | October 27, 2014 16:38 |
Force can not converge | colopolo | CFX | 13 | October 4, 2011 23:03 |
How to add time varying body force | hsieh | OpenFOAM Running, Solving & CFD | 2 | July 26, 2010 12:43 |
Body force at the cell face | Souviktor | Fluent UDF and Scheme Programming | 0 | March 31, 2009 09:54 |
how to add body force in a duct | jane | FLUENT | 0 | March 28, 2004 00:13 |