GGI Error Message

July 15, 2003, 16:57

Hello everyone,

I use CFX-Pre 5.6 to build a model in which five Patran Neutral blocks were imported. Domain Interfaces (no Frame change, no Pitch change) were assigned in the model. When I tried to solver the problem, I got the following error message in CFX 5.6 Solver. Anybody knows the reason and what should I do to revise the model?

Thanks in advance!

David

ERROR #001100279 has occurred in subroutine ErrAction. | Message: | No control surfaces have been found at all for case and drill com- |

. This is not supported.

| ERROR #001100279 has occurred in subroutine ErrAction. Message: Stopped in routine SU_MESH_GGI

July 16, 2003, 01:01

David,

One of your GGI interfaces is not overlapping. Carefully check that side 1 and side 2 are overlapping. You can do this in CFX-Pre or Post.

Neale

July 16, 2003, 12:47

Thank you Neale! You are right.

Regards

David

July 15, 2003, 16:57	GGI Error Message	#1
David Guest Posts: n/a	Hello everyone, I use CFX-Pre 5.6 to build a model in which five Patran Neutral blocks were imported. Domain Interfaces (no Frame change, no Pitch change) were assigned in the model. When I tried to solver the problem, I got the following error message in CFX 5.6 Solver. Anybody knows the reason and what should I do to revise the model? Thanks in advance! David ERROR #001100279 has occurred in subroutine ErrAction. \| Message: \| No control surfaces have been found at all for case and drill com- \| . This is not supported. \| ERROR #001100279 has occurred in subroutine ErrAction. Message: Stopped in routine SU_MESH_GGI

July 16, 2003, 01:01	Re: GGI Error Message	#2
Neale Guest Posts: n/a	David, One of your GGI interfaces is not overlapping. Carefully check that side 1 and side 2 are overlapping. You can do this in CFX-Pre or Post. Neale

July 16, 2003, 12:47	Thank you, Neale	#3
David Guest Posts: n/a	Thank you Neale! You are right. Regards David

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ggi	FabOr	OpenFOAM	17	May 9, 2013 10:19
GGI Tolerance	taner	OpenFOAM Running, Solving & CFD	18	February 12, 2013 15:58
Difference between ggi and overlapGgi? GGI Tips and Tricks?	philippose	OpenFOAM Running, Solving & CFD	7	January 16, 2013 09:40
GGI in OpenFOAM-1.5-dev	philippose	OpenFOAM Running, Solving & CFD	14	November 13, 2011 14:55
Problem using GGI	besto	OpenFOAM	13	October 30, 2010 07:34