How to composite this two surface together???
 

Hello everyone. I am now tring to build an airway geometry of human's lung. But there are something wrong with it. I have post it in the following address. Please help me to have a look at it. http://202.113.227.137/private/adang/airway/flange.html Thank you very much.

Re: How to composite this two surface together???
 

Hi Adang,

It looks like you have created the surface just fine. You still have to close off the ends, however, in order to generate a B-Rep solid. To do so, combine the curves at each end into a single closed loop using Create>Curve>Chain. You can then create planar trimmed surfaces using each loop as the "outer loop" in the Create>Surface>Trimmed form.

Regards, Robin

Re: How to composite this two surface together???
 

Hi, Robin

Thank you very much. With your great help I have got it. :)

Sincerely Adang