 |
 |
 |
|
|
|
[Sponsors] | ||||
August 21, 2003, 13:06
|
tascflow - impeller volute interface
|
#1 |
|
Guest
Posts: n/a
|
I am planning to simulate impeller volute together in Tascflow. Frozen rotor interface applied between impeller outlet and volute inlet. But there should not be any solid surface at interface. In my model vane thickness is coming at the interface. How to deal with it.
Can I simulate impeller and volute separately. In this case impeller can be solved by simulating one passage between the vanes. And after impleller solution how to put it around volute inlet. Send suggestions.... |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
| Volute outlet flow into impeller inlet | Anthony_impeller | CFX | 4 | December 13, 2011 16:17 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
| Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |
Linear Mode
