|September 6, 2003, 22:21||
CFX TASCflow - while-endwhile loop ina macro
I am trying to write a macro that will write rsf files at a number of locations for each time step of a transient solution.
I used 2 While-EndWhile statements, one within the other:-
while (logical expression) command1 ... command 4 while (logical Expression) cammand5 ... command8 endwhile endwhile
When I ran the macro, the commands for the outer loop were completed but the commands for the inner loop were only completed for the last run of the outer loop.
I defined and used the parameter ii in the logic statement of the outer loop and defiined parameter jj for the inner loop, but the parameter jj was not recognised.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Pros and Cons for CFX, CFdesign, COMSOL||Val||Main CFD Forum||3||June 10, 2011 02:20|
|CFX Tascflow Legend||Srinu||CFX||0||July 23, 2002 01:19|
|mesh adaption/refinement in CFX tascflow||N Menon||CFX||0||March 26, 2002 11:05|
|CFX 4.4 installation problem||Pandu Sattvika||CFX||1||December 1, 2001 05:07|
|Interfacing the TASCFLOW and CFX||Bilal Bukhari||CFX||1||February 27, 2001 23:24|