Tetra and Periodicity
 

Hi people,

I'm working with Icem Tetra mesher at the moment. I have a problem with the periodic surfaces, this surfaces are Rotational periodic with 77.14°. The mesh that Tetra makes is usless it does not match with the geometry. But if I have the same model with a periodicity of 77°, than the mesh match with the geometry.

Is possiple with Terta to mesh a geomerty with a Rotational periodicity of not integer angles?

Thanks.

Daniele

Re: Tetra and Periodicity
 

look at this

http://www.cfd-online.com/Forum/main.cgi?read=28205