CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > CFX

Combustion: pool fire problem

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   October 27, 2003, 09:10
Default Combustion: pool fire problem
  #1
Jonathan
Guest
 
Posts: n/a
Hi,

I am using the Eddy Dissipation Model in CFX-5.6 to simulate a burning pool fire (methane/air mix, 1.0m x 1.8m rectangular source in a small room). I set a mass flow of 0.08 kg/s on the fire inlet, corresponding to a fire size of about 3.5 MW.

With time steps of 0.25s and 10 iterations per step, I got a good looking plume up to about 7.5s, which then moved across to one side of the pan whilst thinning out, subsequently disappearing. Seems like something stopped the combustion process for some reason. Velocities around the pan are quite small, so it's not like having a wind blowing into the fire.

Has anyone else had a similar problem modelling pool fires and how was it resolved? At the moment I am trying smaller time steps (0.1 s) but keeping a similar number of iterations per step in order to keep the problem manageable.

Jon.

  Reply With Quote

Old   October 27, 2003, 12:48
Default Re: Combustion: pool fire problem
  #2
Jonathan
Guest
 
Posts: n/a
Could be something to do with flow towards the fire blowing it out. Anyone had a similar problem?

  Reply With Quote

Old   October 27, 2003, 12:49
Default Re: Combustion: pool fire problem
  #3
BAK_FLOW
Guest
 
Posts: n/a
Hi,

I think you will need to hit the textbooks before getting too deep into this simulation. A pool fire is a very strongly coupled probem by which the heat release of the fire drives the heat transfer, mass transfer and flow processes.

The eddy dissipation model is a drastic simplification of the entire combustion process. It is an assumption that the only important process is the time scale of trubulent eddies to "dissipate" ie mix beyond their distinct identity. Since combustion can only occur when fuel and oxidant are mixed down to the mollecular level this model assumes that this is the only process of relevance.

I think you will need to take a few steps back on this one. There is not much use in playing with time step size and number of inner iterations unless you have some relevant physics.

A good place to start is some standard references on poll fires such as:

Introduction to Fire Dynamics Dougal Drysdale

There are also quite a few publications on pool fire simulations in the literature.

Best of luck,

Bak_Flow
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Oil combustion problem brajh11 CFX 1 December 7, 2012 02:49
Converting a Combustion problem to a plain dispersion problem arnabchakrabarty Phoenics 0 May 10, 2010 10:02
Combustion model for CAI/HCCI in AVL FIRE stoodent Main CFD Forum 0 July 19, 2009 19:37
Combustion problem Rams FLUENT 0 June 24, 2006 05:31
Combustion Problem Andrew FLUENT 1 September 3, 2003 06:22


All times are GMT -4. The time now is 11:39.