|
[Sponsors] |
December 2, 2003, 20:46 |
moving water from a chamber using air
|
#1 |
Guest
Posts: n/a
|
Hi
I am looking for help in running an analysis of blowing water out of a flooded compartment (or chamber). The chamber is initially filled with water, then an air source is used to blow the water out of the chamber. How do I go about setting this up. I am new user and I am able to run the analysis with air but not sure how to do both water and air. Thanks. Matt Mason |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem with two phase flow (air injected in water) | miles_davis | OpenFOAM | 15 | March 31, 2021 10:36 |
Simulating air injects to water in a tank | Howard Wang | FloEFD, FloWorks & FloTHERM | 1 | March 16, 2009 04:17 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 22:14 |
Setfields inoutlet and water and air patches | erik023 | OpenFOAM Pre-Processing | 1 | September 29, 2008 11:05 |
VOF-compression of air with rising water | yavuz | FLUENT | 0 | November 26, 2005 10:00 |