|
[Sponsors] |
January 17, 2004, 11:40 |
stream line
|
#1 |
Guest
Posts: n/a
|
Dear All, I am in of your help, I have water flow through a nozzle. when I greated the stream line at inlet in CFx5.6 post. However, the prgram did not draw any thing as line or deoplets. I do know why.
note: (The output water from the nozzle should be droplets) |
|
January 17, 2004, 12:15 |
Re: stream line
|
#2 |
Guest
Posts: n/a
|
Try to reverse the direction of the stream line or set them to flow in both directions. (If you know why - why then ask )))
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 03:09 |
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 09:48 |
Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 05:26 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 16:16 |