CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > CFX

Inlet duct projection

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   February 13, 2004, 20:03
Default Inlet duct projection
  #1
shhe
Guest
 
Posts: n/a
Hi

I am working with cyclone separator (CFX 5.6). I have created inlet duct. I have created curve from intersection between the surface duct and the surface cyclinder of the cyclone. Further, I have trimmed the curves from the cylindert surface. In case of creating solid by method of B-rep, I have the following message:

"A gab exist between two faces of the body"

I have tried to use edit/surface/edge match to close the gab but I have the same problem.

Can any one help me in this problem. Moreover, can anyone inform me how to create the inlet duct with the cyclone and the projection and trimmed surface.

Best regards
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
How to specify an inlet boundary conditions for a fully developed gas flow in a duct. legendyxg FLUENT 2 May 11, 2010 07:32
Inlet shapes for modelling a fan in an inlet duct buzzybee CFX 10 June 11, 2009 20:15
Defining Duct Inlet Pressure Distribution? Eric FLUENT 1 February 8, 2008 16:50
Periodic BC on Inlet and Outlet of a Duct Steve CFX 2 August 8, 2005 12:03
flow simulation across a small fan jane luo Main CFD Forum 15 April 12, 2004 17:49


All times are GMT -4. The time now is 15:22.