|
[Sponsors] |
March 5, 2004, 14:02 |
Help with CFX
|
#1 |
Guest
Posts: n/a
|
Hello, I am new to CFX, we are trying to set it up on 2 Linux computers to run in Parallel, its taken a bit of our time. We thought it was running fine until while writing *.gtm the slave computer suddenly quits. We can't find anything in the manual about this type of error. Perhaps there is someone out there who has done this before who can give us a check list of what to look for or a step by step how to set it up on Linux 7.3 to run in parallel, the program was purchased and given to our department by a subsidiary of German company doing business here. 5 students are desperately trying to use the program, but it keeps quiting on us. Please help.
|
|
March 6, 2004, 15:42 |
Re: Help with CFX
|
#2 |
Guest
Posts: n/a
|
*.gtm file used only in PRE or BUILD... You trying parallel meshing or parallel solving?
|
|
March 6, 2004, 16:25 |
Re: Help with CFX
|
#3 |
Guest
Posts: n/a
|
trying both
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Proper way to name boundaries on 2D model for use in CFX? | RossFS | ANSYS Meshing & Geometry | 4 | November 10, 2011 02:38 |
Pros and Cons for CFX, CFdesign, COMSOL | Val | Main CFD Forum | 3 | June 10, 2011 02:20 |
CFX pressure in Simulations problem | nasdak | CFX | 1 | April 14, 2010 13:22 |
PhD using CFX | Rui | CFX | 9 | May 28, 2007 05:59 |
CFX 4.4 installation problem | Pandu Sattvika | CFX | 1 | December 1, 2001 04:07 |