|
[Sponsors] |
March 11, 2004, 11:29 |
facess of 2d regions are internal???
|
#1 |
Guest
Posts: n/a
|
I have recently encountered a warning when importing a mesh into CFX-Pre. The warning reads:
"The importing process reported the following warning(s) while importing the mesh from the requested file: Faces of 2D region CHANNEL WALLS were detected as being internal. These faces have been ignored." My mesh is a simple rectangular cross-sectioned channel and I have labelled three of the six sides as CHANNEL WALLS, one INLET, one OUTLET, and one INTERFACE. Why would I get this error, and what does it mean? Thanks Mark |
|
May 10, 2004, 01:35 |
Re: facess of 2d regions are internal???
|
#2 |
Guest
Posts: n/a
|
Sorry if it is too late for you.
I am just wondering whether you have used an internal wall with zero wall thickness or not... What apckage did u use to make the geo and mesh?? AR |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Internal boundary problem | stefanke | OpenFOAM Meshing & Mesh Conversion | 2 | May 24, 2011 03:21 |
[Commercial meshers] Fluent Mesh to OpenFoam: Internal Surface has to be a wall | sebastian | OpenFOAM Meshing & Mesh Conversion | 6 | October 21, 2010 05:36 |
mapFields : internal edges | Gearb0x | OpenFOAM Running, Solving & CFD | 3 | April 19, 2010 10:02 |
[Commercial meshers] TGridFluent mesh with internal by prism layer and internal face for diagnostic | sponiar | OpenFOAM Meshing & Mesh Conversion | 2 | March 30, 2009 16:02 |
how to get fluid internal internal energy | vbk | FLUENT | 0 | December 17, 2007 02:54 |