 |
 |
 |
|
|
|
[Sponsors] | ||||
April 16, 2004, 03:36
|
Radius leading edge problem
|
#1 |
|
Guest
Posts: n/a
|
my problem is the leading edge on my geometri not so smooth,i'm use Naca 65009.i need to know how to solve this problem,thanks before
|
|
|
||
|
April 20, 2004, 01:35
|
Re: Radius leading edge problem
|
#2 |
|
Guest
Posts: n/a
|
Finer mesh?
Try angular resolution of 9 degrees or smaller to get more elements in the high curvature area. Jeff |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
| Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
| Through-Flow solver, Leading-Trailing edge problem | Menander | Main CFD Forum | 0 | May 14, 2008 18:14 |
| leading edge vortices | kaushik | CFX | 3 | July 29, 2007 18:33 |
| mesh control problem | TUM | CFX | 4 | July 27, 2001 16:17 |
Linear Mode
