Home > Forums > Software User Forums > ANSYS > CFX

water droplet flow

Mark Forums Read

Reply

Search this Thread

April 27, 2004, 03:36	water droplet flow	#1
F.K. Guest Posts: n/a	I've a question concerning the two phase flow in a cyclone system. The flow consists of air and small water droplets and I want to determine the seperation rate under transient conditions. This means I want to know how much water remains in the system after lets say 20 seconds. With Fluent/Star it is not possible so my question is if Cfx can handle this kind of problem. Thx

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
convergent duct water flow	kkiitm	CFX	0	January 2, 2011 12:11
pressure distribution in water flow, differences in icoFoam and COMSOL	deniggo	OpenFOAM Running, Solving & CFD	14	September 30, 2010 04:48
Two-phase air water flow problems by activating Wall Lubrication Force	challenger85	CFX	5	November 5, 2009 06:44
codes for water hammer on pipe flow	park	Main CFD Forum	0	September 28, 2008 02:43
Evaporating Droplet Flow	shashwat	Main CFD Forum	0	April 2, 2008 10:33

All times are GMT -4. The time now is 07:40.