 |
 |
 |
|
|
|
[Sponsors] | ||||
May 14, 2004, 03:43
|
rms pressure
|
#1 |
|
Guest
Posts: n/a
|
hi,friends can I use cfx5.6 to extract rms pressure from res file,thanks. regards colins
|
|
|
||
|
May 18, 2004, 20:41
|
Re: rms pressure
|
#2 |
|
Guest
Posts: n/a
|
it depends what sort of simulation you are doing doesn't it. how are you simulating it?
|
|
|
|
||
|
May 24, 2004, 00:51
|
Re: rms pressure
|
#3 |
|
Guest
Posts: n/a
|
to James: I am doing a steady simulation,now I don't think CFX5 can extract rms results from the res of steady simulation. regards colins
|
|
|
|
||
|
May 24, 2004, 00:59
|
Re: rms pressure
|
#4 |
|
Guest
Posts: n/a
|
correct
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |
| RMS P-mass no-convergence for low pressure ration,low rotor speed turbine | Ton | CFX | 3 | November 6, 2010 06:21 |
| Setup/monitor points of pressure and force coefficients | siw | CFX | 3 | October 22, 2010 06:07 |
| Operating condition in Fluent | MASOUD | FLUENT | 3 | September 16, 2010 17:50 |
| Setting pressure and velocity in inlet | Asghari | FLUENT | 5 | September 22, 2006 13:23 |
Linear Mode
