how to see the mesh in PRE/POST?

June 10, 2004, 13:56

Hi everybody!

I want to know if there is a way to see the mesh in POST or PRE. It's very urgent!

Have a nice day, Ioana

June 10, 2004, 20:28

Hi Ioana,

Just load the gtm file in post, and then edit the wireframe object setting Edge angle to 0 degrees. that should display your surface mesh in the 3D viewer.

I hope that is the answer you were looking for.

Regards

Paco

June 11, 2004, 02:10

Or if you want to see the mesh (to see the density at particular places or whatever) you define a plain and on render tab for this plane click the "draw lines" on.

in cfx5.7 is the surface mesh displayed from the moment you define the domain. At least it does for me

)).I think.

matej

June 11, 2004, 04:27

Hi Paco & Matej!

Thanks a lot for your advice. It works!

Have a nice day, Ioana

June 10, 2004, 13:56	how to see the mesh in PRE/POST?	#1
ioana Guest Posts: n/a	Hi everybody! I want to know if there is a way to see the mesh in POST or PRE. It's very urgent! Have a nice day, Ioana

June 10, 2004, 20:28	Re: how to see the mesh in PRE/POST?	#2
Francisco A Duque Guest Posts: n/a	Hi Ioana, Just load the gtm file in post, and then edit the wireframe object setting Edge angle to 0 degrees. that should display your surface mesh in the 3D viewer. I hope that is the answer you were looking for. Regards Paco

June 11, 2004, 02:10	Re: how to see the mesh in PRE/POST?	#3
matej Guest Posts: n/a	Or if you want to see the mesh (to see the density at particular places or whatever) you define a plain and on render tab for this plane click the "draw lines" on. in cfx5.7 is the surface mesh displayed from the moment you define the domain. At least it does for me )).I think. matej

June 11, 2004, 04:27	thank you	#4
ioana Guest Posts: n/a	Hi Paco & Matej! Thanks a lot for your advice. It works! Have a nice day, Ioana

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
[ICEM] How to generate sunstructured "all-tri patch-dependant" surface mesh in ICEM?	jash	ANSYS Meshing & Geometry	19	July 23, 2013 18:48
Converting Starccm+ mesh	Ladnam	OpenFOAM	0	September 14, 2011 06:30
basic of mesh refinement	arya	CFX	4	June 19, 2007 12:21
Mesh	Mignard	FLUENT	2	March 22, 2000 05:12