|
[Sponsors] |
June 21, 2004, 09:16 |
About Icem cfd4.cfx
|
#1 |
Guest
Posts: n/a
|
I use Icem cfd4.cfx to bulid geometry and mesh. How can I import the mesh to cfx5.7? Thanks!
|
|
June 21, 2004, 18:15 |
Re: About Icem cfd4.cfx
|
#2 |
Guest
Posts: n/a
|
Go to output and select cfx5 as the solver. You can give the file a name when prompted. In CFX Pre, choose ICEM as the input and search for the file.
Derrek |
|
June 22, 2004, 05:38 |
Re: About Icem cfd4.cfx
|
#3 |
Guest
Posts: n/a
|
But the cfxpre has error as your mehtod
|
|
June 30, 2004, 16:48 |
Re: About Icem cfd4.cfx
|
#4 |
Guest
Posts: n/a
|
hey buddy
those steps are correct. if the problem still persit, then make sure that everything is all right from the ICEM. The domain is probably set. During the export to CFX, make sure that you select appropriate version of the CFX5. Check your version and then select it but if you using CFX5.7 then just select 5.5 or later!!! all the best!! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PEM Fuel cell module meshes. ICEM vs workbench | aarvay | FLUENT | 24 | March 2, 2020 06:50 |
[ANSYS Meshing] Workbench 13: Structured Hexa Meshes | rooftop | ANSYS Meshing & Geometry | 19 | March 31, 2016 02:33 |
[ICEM] complex 2D meshing on ICEM | kassab | ANSYS Meshing & Geometry | 26 | April 14, 2014 21:02 |
Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 03:39 |
ICEM CFD 5.1 Hex-Tet mesh merging failure | bogesz | CFX | 1 | January 29, 2005 06:46 |