|July 17, 2004, 01:49||
error in surface tetmeshing
I've imported a IGES geometry and created a surface mesh of a rectangular box as my flow domain. subsequently i imported an .stl file and tried tet meshing to fill up the inbetween spaces with tetrahedrals.
i've encountered this problem ERR 3103 : EDGE 19927 9141 INTERSECTS WITH EDGE
13847 638 ERROR:3103 - Two edges intersect in surface mesh
is there anything i can do to rectify this and facilitate my meshing?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Error : Self intersecting surface mesh, computing intersections & Error : Impossible||velan||Open Source Meshers: Gmsh, Netgen, CGNS, ...||3||October 22, 2015 11:05|
|Problem with Gmsh||nishant_hull||Open Source Meshers: Gmsh, Netgen, CGNS, ...||23||August 5, 2015 02:09|
|[ICEM] Problems with coedge curves and surfaces||tommymoose||ANSYS Meshing & Geometry||0||August 5, 2011 16:02|
|boundaries with gmshToFoam||ouafa||Open Source Meshers: Gmsh, Netgen, CGNS, ...||7||May 21, 2010 12:43|
|CFX4.3 -build analysis form||Chie Min||CFX||5||July 12, 2001 23:19|