CFD Online Logo CFD Online URL
Home > Forums > CFX

cfx build

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   July 30, 2004, 12:33
Default cfx build
Posts: n/a
dear all,

how to give tolerance value and maximum edge length values in meshing,if my dimensions are in mm.
  Reply With Quote

Old   July 31, 2004, 15:13
Default Re: cfx build
Posts: n/a
It's been a while since I used CFX-Build since CFX stop providing support. Anyway, it depends the version you are using. for v4, before the build environment will upload it'll prompt you for either tolerance or geometry total dimension. Based on what you specified the CFX will automatic compute its tolerance for the mesh. You can also change this tolerance by clicking Preference, then global etc.(check it up on the top tool bar). for v5 you can change it by clicking Preference, then follow screen instruction. Either mm or m, has no influence on it if I'm right since you choose what dimension to work with before drawing or importing your geometry.

PS: Check the USER MANUAL for more details and accurate info. It came with the package and also available online by clicking the HELP on the tool bar.

Best Regards
  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
heat generation in CFX Ema CFX 4 August 7, 2009 05:39
Electronics Enclosure Analysis with CFX Simulation Engineer CFX 1 April 22, 2009 11:08
Importing solutions in CFX. Alphonso CFX 1 August 1, 2008 14:01
Fluent Vs CFX, density and pressure Omer CFX 9 June 28, 2007 04:13
CFX 4.4 installation problem Pandu Sattvika CFX 1 December 1, 2001 05:07

All times are GMT -4. The time now is 08:46.