Home > Forums > Software User Forums > ANSYS > CFX

element volume ratio

Mark Forums Read

Reply

Search this Thread

August 20, 2004, 02:04	element volume ratio	#1
Jack Guest Posts: n/a	Hi, All I am using cad2mesh to build the geometry and generate mesh. One problem I met is that the inlets (I have 10 inlets) are 100 times smaller than the whole geometry. I tried to use control and inflation, but then the final mesh shows very high element volume ratio (>100). Can anyone explain how to reduce the element volume ratio? Thanks in advance! Jack

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 15:11
On the damBreak4phaseFine cases	paean	OpenFOAM Running, Solving & CFD	0	November 14, 2008 22:14
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 15:00

All times are GMT -4. The time now is 21:58.