|
[Sponsors] |
September 2, 2004, 07:25 |
mass fraction boundary value on a WALL ?
|
#1 |
Guest
Posts: n/a
|
How can i set mass fraction boundary value on a WALL ? I want to model condensation proucess on a wall and i need to set saturation criteria on a wall (Cm=Cm(T)).
|
|
September 3, 2004, 00:54 |
Re: mass fraction boundary value on a WALL ?
|
#2 |
Guest
Posts: n/a
|
Hi, At present you can use volumetric additional variable for modeling the moisture. Mass source cannot be specified on the wall in CFX-5.7. But there has been a user fortran which has been developed to do so. Contact your CFX-support group for the same.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error message: Insufficient Catalogue Size | Paresh Jain | CFX | 32 | February 3, 2021 03:37 |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
External Radiation Boundary Condition (Two sided wall), Grid Interface | CFD XUE | FLUENT | 0 | July 8, 2010 06:49 |
Creating a mass point source on a boundary (say, wall) or in Interior (for tracer) | mixer | OpenFOAM Running, Solving & CFD | 3 | August 19, 2009 09:39 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |