|
[Sponsors] |
December 23, 2004, 01:37 |
is it a bug in icem 5.0?
|
#1 |
Guest
Posts: n/a
|
when moving or rotating geometry but forget to choose any object and then press apply. the computer will never respond quickly and keep waitting for quite a long time.at that time i have to shutdown the programming and restart it again becasue it can save me more time than waitting!
|
|
December 23, 2004, 04:37 |
Re: is it a bug in icem 5.0?
|
#2 |
Guest
Posts: n/a
|
There were several nasty insects in ICEM 5.0, which is why they brought out two 160 MB service packs. ANSYS now recommends an upgrade to 5.1, which has fixed many of the nasties of 5.0.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ICEM CFD 5.0 - 2D to 3D Mesh Extrude | James Date | CFX | 7 | October 22, 2013 03:46 |
ICEM CFD 5.0 (Hexa) - Internal Wall/Thin Surface | James Date | CFX | 3 | August 10, 2012 04:47 |
Re: ICEM 5.0 | Joan | CFX | 1 | October 22, 2004 17:05 |
ICEM 5.0 to IGES | Christian | CFX | 0 | September 29, 2004 11:44 |
Free seminar: ICEM CFD version 5.0 | Gavin Butcher | CFX | 0 | June 17, 2004 10:49 |