Re: ICEM 5.0

October 22, 2004, 07:00

Hi everyone! I draw a concentric cylinder using ICEM 5.0, i creat different parts for the cylinder and assign boundary conditions for them. But the .geo file only shows the b.c for inlet and outlet, but not other parts inside the cylinder. Do anyone know how i can assign boundary conditions for the parts inside the cylinder?

Thanks Joan

October 22, 2004, 17:05

Hi

I assume you're using Hexa. If so, it might be something to do with you not correctly associating faces to surface parts.

Regards James

October 22, 2004, 07:00	Re: ICEM 5.0	#1
Joan Guest Posts: n/a	Hi everyone! I draw a concentric cylinder using ICEM 5.0, i creat different parts for the cylinder and assign boundary conditions for them. But the .geo file only shows the b.c for inlet and outlet, but not other parts inside the cylinder. Do anyone know how i can assign boundary conditions for the parts inside the cylinder? Thanks Joan

October 22, 2004, 17:05	Re: ICEM 5.0	#2
James Date Guest Posts: n/a	Hi I assume you're using Hexa. If so, it might be something to do with you not correctly associating faces to surface parts. Regards James

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ICEM CFD 5.0 - 2D to 3D Mesh Extrude	James Date	CFX	7	October 22, 2013 03:46
ICEM CFD 5.0 (Hexa) - Internal Wall/Thin Surface	James Date	CFX	3	August 10, 2012 04:47
Problem with ICEM CFD 5.0	sac	CFX	4	October 15, 2004 11:28
ICEM 5.0 to IGES	Christian	CFX	0	September 29, 2004 11:44
Free seminar: ICEM CFD version 5.0	Gavin Butcher	CFX	0	June 17, 2004 10:49