ICEM CFD 5.0 - CFX mesh problem

November 6, 2004, 13:09

I tried to model by using Tet mesh, after mesh, there always an error saying "there is a hole in the geometry", how could I fix this? Actually there is no hole in my model.

November 25, 2004, 09:35

Try to decrease the triangulation tolerance under the global mesh tab.

January 4, 2005, 14:45

Hi,

i don't know if it is possible to create an external mesh. I need to pass water in a catamaran hull, and i would like to do it like in FloWorks (the assembly in a BOX (boundary condition)). Is it possible?

Hugo Ferreira www.dee.isep.ipp.pt/~e980933

November 6, 2004, 13:09	ICEM CFD 5.0 - CFX mesh problem	#1
NeedHelp Guest Posts: n/a	I tried to model by using Tet mesh, after mesh, there always an error saying "there is a hole in the geometry", how could I fix this? Actually there is no hole in my model.

November 25, 2004, 09:35	Re: ICEM CFD 5.0 - CFX mesh problem	#2
johan Guest Posts: n/a	Try to decrease the triangulation tolerance under the global mesh tab.

January 4, 2005, 14:45	Create an external mesh	#3
Hugo Ferreira Guest Posts: n/a	Hi, i don't know if it is possible to create an external mesh. I need to pass water in a catamaran hull, and i would like to do it like in FloWorks (the assembly in a BOX (boundary condition)). Is it possible? Hugo Ferreira www.dee.isep.ipp.pt/~e980933

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ICEM CFD to CFX geometry and mesh	Luca	CFX	6	February 4, 2010 17:31
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55
Error Converting ICEM Structured Mesh to CFX	Chebeba	CFX	11	October 5, 2006 09:05
CFX mesh & ICEM	mike	CFX	3	April 27, 2006 16:27
Mesh from ICEM CFD to CFX ! Error ! Why ? Thanks !	Vu Trinh Tuan	CFX	11	March 28, 2005 20:04