CFX4 to CFX5

November 24, 2004, 07:40

Hello there

I have number of problems specifying BCs in CFX-5. How do I specify FRACTIONAL MASS FLOW BOUNDARIES in CFX-5 ?

Typical CFX-4 command
:>MASS FLOW BOUNDARIES

>>FLUX

FRACTIONAL MASS FLOW SPECIFIED

FLUXES 0.5 0.5

END

How do I specify AXIS SYMMETRY BOUNDARIES in CFX-5 ?

Thanks for your help.

Kumar

December 16, 2004, 15:08

Fractional mass flow is not directly available in CFX-5.

You must create mass flow inlets/outlets and specify the exact amount you want coming in/out. i.e. if you know the total mass flow rate manually divide things up.

Neale

November 24, 2004, 07:40	CFX4 to CFX5	#1
Kumar Guest Posts: n/a	Hello there I have number of problems specifying BCs in CFX-5. How do I specify FRACTIONAL MASS FLOW BOUNDARIES in CFX-5 ? Typical CFX-4 command :>MASS FLOW BOUNDARIES >>FLUX FRACTIONAL MASS FLOW SPECIFIED FLUXES 0.5 0.5 END How do I specify AXIS SYMMETRY BOUNDARIES in CFX-5 ? Thanks for your help. Kumar

December 16, 2004, 15:08	Re: CFX4 to CFX5	#2
Neale Guest Posts: n/a	Fractional mass flow is not directly available in CFX-5. You must create mass flow inlets/outlets and specify the exact amount you want coming in/out. i.e. if you know the total mass flow rate manually divide things up. Neale

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Multiphase in CFX4 and CFX5	Anne	CFX	8	October 30, 2004 21:20
a qestion about CFX4 and CFX5	cfxbeginner	CFX	2	October 25, 2002 08:01
Opinion about CFX4 and CFX5	Jan Rusås	CFX	17	August 17, 2002 16:28
why is it not convergence in CFX4 but in CFX5?	ycfxbeginer	CFX	1	January 27, 2002 16:32
Convert CFX4 dmp's to CFX5 Res's?	Michael Bo Hansen	CFX	3	May 10, 2001 08:55