is it a bug in icem 5.0?

December 23, 2004, 01:37

when moving or rotating geometry but forget to choose any object and then press apply. the computer will never respond quickly and keep waitting for quite a long time.at that time i have to shutdown the programming and restart it again becasue it can save me more time than waitting!

December 23, 2004, 04:37

There were several nasty insects in ICEM 5.0, which is why they brought out two 160 MB service packs. ANSYS now recommends an upgrade to 5.1, which has fixed many of the nasties of 5.0.

December 23, 2004, 01:37	is it a bug in icem 5.0?	#1
hyb Guest Posts: n/a	when moving or rotating geometry but forget to choose any object and then press apply. the computer will never respond quickly and keep waitting for quite a long time.at that time i have to shutdown the programming and restart it again becasue it can save me more time than waitting!

December 23, 2004, 04:37	Re: is it a bug in icem 5.0?	#2
Charles Guest Posts: n/a	There were several nasty insects in ICEM 5.0, which is why they brought out two 160 MB service packs. ANSYS now recommends an upgrade to 5.1, which has fixed many of the nasties of 5.0.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ICEM CFD 5.0 - 2D to 3D Mesh Extrude	James Date	CFX	7	October 22, 2013 03:46
ICEM CFD 5.0 (Hexa) - Internal Wall/Thin Surface	James Date	CFX	3	August 10, 2012 04:47
Re: ICEM 5.0	Joan	CFX	1	October 22, 2004 17:05
ICEM 5.0 to IGES	Christian	CFX	0	September 29, 2004 11:44
Free seminar: ICEM CFD version 5.0	Gavin Butcher	CFX	0	June 17, 2004 10:49