 |
 |
 |
|
|
|
[Sponsors] | ||||
December 28, 2004, 13:57
|
Internal boundary condition
|
#1 |
|
Guest
Posts: n/a
|
Hi
My problem is that I would like to set an internal boundary condition on an internal surface (which cuts the domain in the middle). I'm using ICEM to mesh my domain. After selecting this surface in the internal wall option, the mesh generated stops until this surface and the remaining part of the domain is not meshed. Maybe I don't used this option correctly? Someone has an idea how to solve this problem? Thanks |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Boundary Conditions | Thomas P. Abraham | Main CFD Forum | 20 | July 7, 2013 05:05 |
| inlet velocity boundary condition | murali | CFX | 5 | August 3, 2012 08:56 |
| External Radiation Boundary Condition (Two sided wall), Grid Interface | CFD XUE | FLUENT | 0 | July 8, 2010 06:49 |
| how to set up a wall boundary condition according to calculated wall shear stress? | gameoverli | OpenFOAM Pre-Processing | 1 | May 21, 2009 08:28 |
| Boundary Condition of internal Faces | Gernot | FLUENT | 5 | August 26, 2005 13:02 |
Linear Mode
