 |
 |
 |
|
|
|
[Sponsors] | ||||
January 13, 2005, 22:20
|
CFX 5.7 ->Tecplot 10 only one zone?
|
#1 |
|
Guest
Posts: n/a
|
When CFX 5.7 ressult was imported into tecplot 10 through CGNS format, the whole fluid domain seemed only one zone. All the boundaries were integrated into the zone. How to solve this problem? thanksŁĄ
|
|
|
||
|
January 15, 2005, 05:37
|
Re: CFX 5.7 ->Tecplot 10 only one zone?
|
#2 |
|
Guest
Posts: n/a
|
because you use CFX computed the unstructe grid.so just one zone.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 16:45 |
| CFX 5.7 solver error | Neser | CFX | 9 | March 1, 2005 11:59 |
| Predefined velocity field implementation CFX 5.7 | Matjaz | CFX | 3 | September 13, 2004 08:26 |
| CFX 5.7 mesh refinement troubles | imike | CFX | 1 | July 8, 2004 19:16 |
| Sliding mesh error | Karl Kevala | FLUENT | 4 | February 21, 2001 16:52 |
Linear Mode
