solid-solid interface

March 7, 2005, 05:26

Hello all, with solid-solid interface boundary condition for multilayers materials, it is possible to take into acount thermal contact resistance ? if it's possible, could you tell me how to do it thanks in advance. Mohamed.

March 7, 2005, 16:38

Hi,

There is no simple model for thermal resistance. I think it is under consideration for CFX 5.8 (no guarantees). For the time being, you may be able to insert an intermediate block with properties chosen to have the same thermal resistance. Just an idea.

Glenn Horrocks

March 8, 2005, 03:05

Dear Horrocks,

Thank you for your suggestion. Regards

March 7, 2005, 05:26	solid-solid interface	#1
Mohamed Guest Posts: n/a	Hello all, with solid-solid interface boundary condition for multilayers materials, it is possible to take into acount thermal contact resistance ? if it's possible, could you tell me how to do it thanks in advance. Mohamed.

March 7, 2005, 16:38	Re: solid-solid interface	#2
Glenn Horrocks Guest Posts: n/a	Hi, There is no simple model for thermal resistance. I think it is under consideration for CFX 5.8 (no guarantees). For the time being, you may be able to insert an intermediate block with properties chosen to have the same thermal resistance. Just an idea. Glenn Horrocks

March 8, 2005, 03:05	Re: solid-solid interface	#3
Mohamed Guest Posts: n/a	Dear Horrocks, Thank you for your suggestion. Regards

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 05:45
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55
Replace periodic by inlet-outlet pair	lego	CFX	3	November 5, 2002 20:09
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19