|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi everybody!
I need to monitor the average temperature on a plane in the solver. But from Pre I noticed that is it posible only to use the areAve function only for the boundary conditions and domains created. My plane is not definded in Pre. Any ideas? caty |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Hi,
To do it in the solver you have to define some sort of boundary patch at that point. If you split your mesh at that plane and join it with a 1:1 interface you can do calculations on the interface. Note it will slightly increase your simulation time but for a 1:1 interface the increase is very small. Alternately you can do it in CFX-Post in post-processing. Glenn Horrocks |
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
How can I split the mesh?? Only in the meshing software or i can do it in Pre as well?
|
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
Hi,
Splitting the mesh must be done in the meshing software. CFX-Pre cannot do anything with the mesh, except simple transformations such as translations, scaling, rotations. Regards, Glenn Horrocks |
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
Quarter Burner mesh with periosic condition | SamCanuck | FLUENT | 2 | August 31, 2011 11:34 |
Working directory via command line | Luiz | CFX | 4 | March 6, 2011 20:02 |
why the solver reject it? Anyone with experience? | bearcat | CFX | 6 | April 28, 2008 14:08 |
Mixing plane geometry definition | Hbet | FLUENT | 0 | January 18, 2002 07:16 |