|
[Sponsors] |
April 24, 2005, 08:42 |
ICEM TETRA
|
#1 |
Guest
Posts: n/a
|
HI,ALL
I finished meshing a geometry with tetra grid. When checked the mesh, I found there were some problems such as Non-manifold vertices and Multiple Edges.I have no idea of how to handle them.I want to know basically what should i do. Could you please give me some recommandation. thanks in advance. B.R. charles |
|
April 25, 2005, 18:28 |
Re: ICEM TETRA
|
#2 |
Guest
Posts: n/a
|
Hi,
Note non-manifold edges and multiple edges are warnings, not errors. Depending on your geometry they may be OK. It is discussed in the documentation. Glenn Horrocks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Exporting ICEM Tetra Grid to Fluent with Hexa-Core | Tim | FLUENT | 2 | August 30, 2007 07:16 |
Icem tetra - Running in parrallel? | Joe | CFX | 5 | September 9, 2006 12:37 |
ICEM CFD 5.1 problem with tetra count | Baskaran | CFX | 2 | March 13, 2006 12:59 |
ICEM TETRA | Ram | CFX | 2 | April 22, 2005 03:47 |
Have you used ICEM CFD TETRA and HEXA ? | David | Main CFD Forum | 1 | August 22, 2000 08:56 |