 |
 |
 |
|
|
|
[Sponsors] | ||||
May 10, 2005, 09:36
|
Meshing ring
|
#1 |
|
Guest
Posts: n/a
|
Hi
I'm using ICEM 5.0 and 5.1 to mesh a ring of rectangular cross section with hexa, but I have some problems. Does someone know a trick for the blocking strategy as the blocks can only be square or rectangle? Thanks for help Thomas |
|
|
||
|
May 10, 2005, 11:14
|
Re: Meshing ring
|
#2 |
|
Guest
Posts: n/a
|
Hi,
Yep, you should be able to get a really nice grid if you make an 0-grid with the centre square removed and map the remaining outer and inner o-grid edges the the ring edges. Not sure if this makes much sense! James |
|
|
|
||
|
May 11, 2005, 06:27
|
Re: Meshing ring
|
#3 |
|
Guest
Posts: n/a
|
Thanks James, it's working well! Thomas
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
| Meshing Ring Element | Jalen | ANSYS Meshing & Geometry | 2 | October 20, 2009 09:21 |
| Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |
| Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 11:09 |
| Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |
Linear Mode
