Problem about contour

June 28, 2005, 22:42

Hi

When I checked the "show numbers" checkbox in the contour card, I found that the number had been showed is 1,2,3,4......

How can I get the factual value of the contour in Post?

All your advice will be very appreciated.

June 29, 2005, 07:44

Hi,

I think you can't.But if have checked the "show numbers" box, when you create a Legend, or on the Default Legend, you'll be able to see the contour labels between brackets and their respective values.

Regards,

Rui

July 1, 2005, 22:36

Rui

Thank you for your help.

I have another question. In Turbgrid 2.2.1 I cann't use the H grid for the tip of a turbine rotor . Thus I used the "H- no matching "selection. But it seems that this kind of mesh of a tip is difficult to converge.

Could you offer me some idea for dealing this?

July 2, 2005, 09:53

Hi,

I'm sorry but I can't help you. I just work with CFX-5, I've never used Turbogrid.

July 2, 2005, 21:57

Rui

Thank you all the time.

June 28, 2005, 22:42	Problem about contour	#1
LQ Guest Posts: n/a	Hi When I checked the "show numbers" checkbox in the contour card, I found that the number had been showed is 1,2,3,4...... How can I get the factual value of the contour in Post? All your advice will be very appreciated.

June 29, 2005, 07:44	Re: Problem about contour	#2
Rui Guest Posts: n/a	Hi, I think you can't.But if have checked the "show numbers" box, when you create a Legend, or on the Default Legend, you'll be able to see the contour labels between brackets and their respective values. Regards, Rui

July 1, 2005, 22:36	Re: Problem about contour	#3
LQ Guest Posts: n/a	Rui Thank you for your help. I have another question. In Turbgrid 2.2.1 I cann't use the H grid for the tip of a turbine rotor . Thus I used the "H- no matching "selection. But it seems that this kind of mesh of a tip is difficult to converge. Could you offer me some idea for dealing this?

July 2, 2005, 09:53	Re: Problem about contour	#4
Rui Guest Posts: n/a	Hi, I'm sorry but I can't help you. I just work with CFX-5, I've never used Turbogrid.

July 2, 2005, 21:57	Re: Problem about contour	#5
LQ Guest Posts: n/a	Rui Thank you all the time.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
area does not match neighbour by ... % -- possible face ordering problem	St.Pacholak	OpenFOAM	10	February 7, 2024 21:50
conduction problem	venkataramana	OpenFOAM	3	December 1, 2013 07:30
Problem Importing Geometry ProE to CFX	fatb0y	CFX	3	January 14, 2012 19:42
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13
Is this problem well posed?	Thomas P. Abraham	Main CFD Forum	5	September 8, 1999 14:52