|
[Sponsors] |
June 28, 2005, 22:42 |
Problem about contour
|
#1 |
Guest
Posts: n/a
|
Hi
When I checked the "show numbers" checkbox in the contour card, I found that the number had been showed is 1,2,3,4...... How can I get the factual value of the contour in Post? All your advice will be very appreciated. |
|
June 29, 2005, 07:44 |
Re: Problem about contour
|
#2 |
Guest
Posts: n/a
|
Hi,
I think you can't.But if have checked the "show numbers" box, when you create a Legend, or on the Default Legend, you'll be able to see the contour labels between brackets and their respective values. Regards, Rui |
|
July 1, 2005, 22:36 |
Re: Problem about contour
|
#3 |
Guest
Posts: n/a
|
Rui
Thank you for your help. I have another question. In Turbgrid 2.2.1 I cann't use the H grid for the tip of a turbine rotor . Thus I used the "H- no matching "selection. But it seems that this kind of mesh of a tip is difficult to converge. Could you offer me some idea for dealing this? |
|
July 2, 2005, 09:53 |
Re: Problem about contour
|
#4 |
Guest
Posts: n/a
|
Hi,
I'm sorry but I can't help you. I just work with CFX-5, I've never used Turbogrid. |
|
July 2, 2005, 21:57 |
Re: Problem about contour
|
#5 |
Guest
Posts: n/a
|
Rui
Thank you all the time. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 21:50 |
conduction problem | venkataramana | OpenFOAM | 3 | December 1, 2013 07:30 |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |