profile BC

June 21, 2005, 05:00

Hi,

we want to use profile boundary condition at inlet to diffuser. We have results from the impeller and we use outlet velocity profile as intlet boundary condition to diffuser. We follow method described in CFX-Help and when we see this imported profile to the inlet of diffuser it isn't the same as in the outlet of the impeller.

We haven't the same mesh at these two boundaries. Is it the problem?

Thanks for your help.

Jindra a Petr

July 4, 2005, 03:08

you must have the same physiscal plane (surface) for booth boundary conditions.

June 21, 2005, 05:00	profile BC	#1
Jindra a Petr Guest Posts: n/a	Hi, we want to use profile boundary condition at inlet to diffuser. We have results from the impeller and we use outlet velocity profile as intlet boundary condition to diffuser. We follow method described in CFX-Help and when we see this imported profile to the inlet of diffuser it isn't the same as in the outlet of the impeller. We haven't the same mesh at these two boundaries. Is it the problem? Thanks for your help. Jindra a Petr

July 4, 2005, 03:08	Re: profile BC	#2
vlado Guest Posts: n/a	you must have the same physiscal plane (surface) for booth boundary conditions.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
3D UDF Paraboilc Velocity Profile (Can't Maintain)	Sing	FLUENT	12	August 7, 2017 06:25
Boundary Profile	E61	FLUENT	0	January 5, 2011 08:13
problem with importing and exporting profile BC	Gui	CFX	2	July 26, 2007 08:50
Associating profile files for the UDS though a UDF	Bharath	FLUENT	0	December 1, 2006 15:58
Wind profile	tom	Phoenics	2	September 28, 2005 10:51