|July 6, 2005, 11:05||
GETADD...some Help Pls
Previously I have carried out the following operation, setting up workspace in USRWRK, Dumping COND(INODE,1,1) into this workspace and then obtaining this workspace with COND values in USRTRN:
CALL GETADD('USRCND','PERMR ','USRDC ',ILEVEL,IUSRDC)
SET SOMETHING IN THIS WORKSPACE...
THEN I WROTE THIS VALUE IN USRTRN...
CALL GETADD('USRTRN','PERMR ','USRDC ',ILEVEL,IUSRDC)
The above procedure seems to work fine
However, in a new case I want to put a boundary condition for SCAL at the fluid/solid (in a CHT model) boundary to have a flux dependent on the sink rate supplied in USRSRC ...
Applying as I have done before:
CALL GETADD('USRSRC','PERMR ','USRDC ',ILEVEL,IUSRDC)
SET SOMETHING IN THIS WORKSPACE... WORK(IUSRDC+INODE-1)=G4
Where G4=a value
CALL GETADD('USRBCS','PERMR ','USRDC ',ILEVEL,IUSRDC)
The WORK(IUSRDC+INODE-1) in the 2nd case produces a value of zero!
There is obviously I am doing something wrong...Can anyone help!...
|Thread||Thread Starter||Forum||Replies||Last Post|
|help me understand porous media in fluent~ pls pls.. :(||naftalena||FLUENT||0||February 28, 2010 13:20|
|i need help following problem pls pls help||gmani||CFX||4||March 31, 2009 09:39|
|Pls. help with particle tracking||Daddy||CFX||4||August 16, 2007 04:34|
|Pls reply how to do multizone in icem||Michael||CFX||0||October 15, 2006 23:29|
|multi phase flows....pls help...||karthik||FLUENT||0||November 16, 2005 10:15|