An error occured - simulation of blower
 

Dear all,

I m doing a blower project simulation in CFX and i m facing some problem in solver ,an error has occurred

ERROR #001100279 has occurred in subroutine ErrAction. Message: ****** FATAL ERROR ****** Finite pitch angle gap could not be found

Could anyone plz help me for this issue checked the boundary condition...everything is fine

i want an immediate reply Regards Rashmi V

Re: An error occured - simulation of blower
 

what were you blowing. :)

Re: An error occured - simulation of blower
 

Hi Rashmi,

I think there is a more polite way of asking for help rather then sating that you want help immediately.

Well I suppose that you are using Multiple frames of references. The domain which is rotating should have a small patch which will not rotate. Usually this is the shaft. I suppose that you have not modelled it. Any turbo experts around here would be able to help you precisely.

Regards, test

Re: An error occured - simulation of blower
 

i have modeled the shaft hole also i m trying to reduce the mesh size in the sense coarsen the mesh.....and solve it.

thank you for ur immediate response i think i m quite polite in asking the queries ok if anything wrong plz forgive me.

may be i m in hurry and so i may have written like that

regards Rashmi v Rao