 |
 |
 |
|
|
|
[Sponsors] | ||||
October 4, 2005, 06:01
|
Hole in pressure plot
|
#1 |
|
Guest
Posts: n/a
|
Strange problem in CFX 5.7.1. I've obtained results for airfoil in subsonic stream and plotted 2D graph (pressure on surface depending on X coordinate). Not bad distribution except little (2-3% of chord) zone, where no line, just a hole. Considering ForceX parameter (affecting on drag) I see great increasing of ForceX in this region. What can it be?
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Plot pressure distribution on a section of 3d blade | Dr.been | FLUENT | 2 | July 22, 2016 06:03 |
| "Pressure Inlet" Boundary Setup | Wijaya | FLUENT | 15 | May 18, 2016 11:08 |
| Fluent natural ventilation pressure boundary condition | pierresandre | FLUENT | 24 | November 8, 2011 15:32 |
| Pressure BC for combustion chamber | Giuki | FLUENT | 1 | July 19, 2011 12:35 |
| Plot Pressure vs Time (transient analysis) | Santiago Orrego | CFX | 1 | October 30, 2007 11:11 |
Linear Mode
