Error while setting up porous material.

October 7, 2005, 03:13

Hi,all
system:Linux, CFX571
problem: As I run a porous simulation with fan( a momentum source), it shows error message after 1st iteration:
<font color=green size=2>
| ERROR #001100279 has occurred in subroutine ErrAction. |
| Message: |
| Subsystem zone not found in SYMASS_ZONE </font>

But as I cancel the porous setting(<font color=blue> note: the model and cfx_pre file are the same as previous except the porous subdomain deleted</font>), then it will be OK .
Does anybody know why?

October 10, 2005, 11:42

It's due to nature of CFX571, nothing to do with the setup and model. Because I put it into CFX10 , and it's ok now !

October 7, 2005, 03:13	Error while setting up porous material.	#1
Kiddo Guest Posts: n/a	Hi,all system:Linux, CFX571 problem: As I run a porous simulation with fan( a momentum source), it shows error message after 1st iteration: <font color=green size=2> \| ERROR #001100279 has occurred in subroutine ErrAction. \| \| Message: \| \| Subsystem zone not found in SYMASS_ZONE </font> But as I cancel the porous setting(<font color=blue> note: the model and cfx_pre file are the same as previous except the porous subdomain deleted</font>), then it will be OK . Does anybody know why?

October 10, 2005, 11:42	solved!	#2
Kiddo Guest Posts: n/a	It's due to nature of CFX571, nothing to do with the setup and model. Because I put it into CFX10 , and it's ok now !

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 06:21
Constant velocity of the material	Sas	CFX	15	July 13, 2010 09:56
Cells with t below lower limit	Purushothama	Siemens	2	May 31, 2010 22:58
Two-Phase Buoyant Flow Issue	Miguel Baritto	CFX	4	August 31, 2006 13:02
Warning 097-	AB	Siemens	6	November 15, 2004 05:41