mehul
|
October 31, 2005 07:01 |
hex mesh using cfx mesh.
Hi to all, i am using cfx 10.Earlier i have used cfx 5.6.I want to know is it possible to hex mesh using Ansys cfx 10 .If yes then how to do it? I know that in cfx 5.6 in patran mesh we can do it.But in cfx 10 mesh i do not know.i have to do FSI .so,I have to do flow analysis and i have to transfer that results (on surface) to ansys so that strucrural anlysis can be done.Pls also tell me that tet mesh will be suitable or not.Because i have tried by tet emesh andgot reults now i am thinking that hex will be suitable.iI want to know that whenever flow problems are done how much hex and tete mes hresults differ? plss reply me. Thaks
|