|
[Sponsors] |
October 31, 2005, 08:01 |
hex mesh using cfx mesh.
|
#1 |
Guest
Posts: n/a
|
Hi to all, i am using cfx 10.Earlier i have used cfx 5.6.I want to know is it possible to hex mesh using Ansys cfx 10 .If yes then how to do it? I know that in cfx 5.6 in patran mesh we can do it.But in cfx 10 mesh i do not know.i have to do FSI .so,I have to do flow analysis and i have to transfer that results (on surface) to ansys so that strucrural anlysis can be done.Pls also tell me that tet mesh will be suitable or not.Because i have tried by tet emesh andgot reults now i am thinking that hex will be suitable.iI want to know that whenever flow problems are done how much hex and tete mes hresults differ? plss reply me. Thaks
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 07:21 |
CFX mesh refining and stiffening | george | CFX | 3 | September 3, 2008 06:31 |
Hex mes husing CFX mesh | john | CFX | 1 | November 6, 2005 17:35 |
How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 10:38 |
importing mesh from ICEM CFD into CFX 5 | Jay | CFX | 2 | November 12, 2002 14:46 |