|
[Sponsors] |
Low Inlet Turb. Intensity - SST model not converge |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 12, 2005, 02:26 |
Low Inlet Turb. Intensity - SST model not converge
|
#1 |
Guest
Posts: n/a
|
Hi,
I'm simulating flow in a diffusing bend. The inlet turbulent intensity that I measured from exp is only 0.5%. However, I found it very difficult to converge using such a low TI in SST model (residuals flat at 10^-3 for 1000 steps). I have to set TI as high as 3% to get the solution to converge to 10E-6. Anyone know how to modify the parameters in SST model to improve the convergence? Thanks,Pete |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
Understanding k-omega SST model source code | tmhonka | OpenFOAM Programming & Development | 1 | September 8, 2009 08:33 |
How to model Low Reynolds Turbulent in SST K-omega | asghari | FLUENT | 0 | August 18, 2007 04:31 |
jet oscillation at low inlet Re | wood | Main CFD Forum | 1 | October 21, 1999 14:45 |
a low Re number model for impinging jets | mahesh prakash | Main CFD Forum | 14 | September 3, 1999 17:40 |