 |
 |
 |
|
|
|
[Sponsors] | ||||
November 23, 2005, 15:50
|
Cavity presntation on pump blade
|
#1 |
|
Guest
Posts: n/a
|
Hello everyone,
I'm modelling cavitation inside pump. I'd like to present cavity on blade surface as a 3D cavity using CFX-post. Is that possible and how I can do it. Ali |
|
|
||
|
November 23, 2005, 16:14
|
Re: Cavity presntation on pump blade
|
#2 |
|
Guest
Posts: n/a
|
Hi,
In CFX-Post, do an iso-surface of volume fraction. Glenn Horrocks |
|
|
|
||
|
November 24, 2005, 12:24
|
Re: Cavity presntation on pump blade
|
#3 |
|
Guest
Posts: n/a
|
Thank you Glenn, this is very helpful
Ali |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Calculating lift force of a wind turbine blade problem | LittleBart | CFX | 4 | June 29, 2011 02:33 |
| [GAMBIT] influence between angle in impeller blade and centrifugal pump performance | barak182 | ANSYS Meshing & Geometry | 2 | August 18, 2010 03:07 |
| Regenerative pump modelled in FLOEFD pro | YYY | FloEFD, FloWorks & FloTHERM | 2 | October 5, 2009 05:04 |
| meshing blade centrifugal pump | mino | CFX | 5 | December 2, 2006 00:54 |
| Calculate pressure on pump blade during cavitation | CFX_USER | CFX | 0 | April 12, 2006 12:54 |
Linear Mode
