 |
 |
 |
|
|
|
[Sponsors] | ||||
November 28, 2005, 23:19
|
icem blocking
|
#1 |
|
Guest
Posts: n/a
|
Hi when a block is deleted,can I reactivate it ,how can i do it? Thx
|
|
|
||
|
November 30, 2005, 01:59
|
Re: icem blocking
|
#2 |
|
Guest
Posts: n/a
|
1) Use 'undo' button 2) Create new block, specifying edges
|
|
|
|
||
|
November 30, 2005, 08:54
|
Re: icem blocking
|
#3 |
|
Guest
Posts: n/a
|
If you're using version 5.0 or above - deleting a block (without delete permanently turned on) simply moves the block into the VORFN part. So - you could also add the block back into the Part of interest by viewing the VORFN part and selecting the block to add back into the active Part.
|
|
|
|
||
|
November 30, 2005, 10:23
|
Re: icem blocking
|
#4 |
|
Guest
Posts: n/a
|
I will try,Thanks!
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Using Blocking with ICEM (infinity lines appear) | Touré | ANSYS Meshing & Geometry | 6 | August 5, 2012 17:07 |
| No Blocking tab in Ansys ICEM CFD11.0 | NewGuy | CFX | 1 | November 22, 2010 15:38 |
| Ansys ICEM 12.0 Searching for tutorial information on complex 3d blocking | Raoul | ANSYS | 1 | October 18, 2010 06:08 |
| ICEM blocking | Chris Wetton | CFX | 6 | March 9, 2008 05:18 |
| ICEM Blocking 2D and Fluent error | Dr. Flow Squad | FLUENT | 3 | March 5, 2007 02:27 |
Linear Mode
