ICEM-AUTOHEX -- CFD Online Discussion Forums

January 10, 2006, 08:59	ICEM-AUTOHEX	#1
tommy Guest Posts: n/a	I perform an autohex mesh in a cubic cell by ANSYS ICEM CFD. Should I also performe "surface mesh" on my 6 families (they are each side of my cubic cell)? best regards

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
PEM Fuel cell module meshes. ICEM vs workbench	aarvay	FLUENT	24	March 2, 2020 06:50
[ANSYS Meshing] Workbench 13: Structured Hexa Meshes	rooftop	ANSYS Meshing & Geometry	19	March 31, 2016 02:33
Design Modeler to ICEM.....	Joe	CFX	0	January 24, 2008 03:39
ICEM 10 mesh scale foe CFX	Korsh Mik	CFX	2	October 7, 2005 09:07
ICEM CFD 5.1 Hex-Tet mesh merging failure	bogesz	CFX	1	January 29, 2005 06:46

All times are GMT -4. The time now is 20:49.