Please Help which model should I use

February 3, 2006, 12:03

I am doing the steckler experiment by using CFX. when i use the k-ε model, the central fire location is ok, but the result of corner location is quite different from the steckler experiment. i am quite sure my other setting is no problem.

My question is which model can i use except the k-ε model. Any other recommendation can give me.

thx

February 13, 2006, 05:14

k E is no good near walls try using kW or SST

February 13, 2006, 12:54

I had tried the k omega and SST model. The can't had a good resul. I tried the BSL renold stess, it gave a perfect result, but when i changed the door size, some door size cases were very bad. i dont know what happen.

recently, i tried the omega renold model, it gave the result is ok but not accuracy.

i had tried a hundred times in this experiment. what can i do to make it better.

February 3, 2006, 12:03	Please Help which model should I use	#1
Peter Guest Posts: n/a	I am doing the steckler experiment by using CFX. when i use the k-ε model, the central fire location is ok, but the result of corner location is quite different from the steckler experiment. i am quite sure my other setting is no problem. My question is which model can i use except the k-ε model. Any other recommendation can give me. thx

February 13, 2006, 05:14	Re: Please Help which model should I use	#2
iyerganapathyv Guest Posts: n/a	k E is no good near walls try using kW or SST

February 13, 2006, 12:54	Re: Please Help which model should I use	#3
Lawrence Guest Posts: n/a	I had tried the k omega and SST model. The can't had a good resul. I tried the BSL renold stess, it gave a perfect result, but when i changed the door size, some door size cases were very bad. i dont know what happen. recently, i tried the omega renold model, it gave the result is ok but not accuracy. i had tried a hundred times in this experiment. what can i do to make it better.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
question about turbulence model selection and sensitivity	karananand	Main CFD Forum	1	February 26, 2010 04:41
Centrifugal Pump and Turbulence Model	Michiel	CFX	12	January 25, 2010 03:20
Problems bout CFD model of biomass gasification, Downdraft gasifier	wanglong	FLUENT	2	November 25, 2009 23:27
Reynolds Stress model in CFX vs Fluent	Tim	CFX	1	October 7, 2009 06:19
Grid resolution for full-scale and down scaled model	gravis	Main CFD Forum	0	October 2, 2009 10:27